E-mail sinonshseo@gmail.com
Time:2025-03-31 13:28:34 Reading volume:
During the use of the oil filter equipment, it is necessary to pay attention to the operating details to prevent unnecessary failures that affect production efficiency. Specifically, the following issues should be noted when using the oil filter:
1. When used on site, the oil filter should be as close to the oil storage equipment as possible, the oil suction pipeline should be moderate, and the pipeline resistance should be reduced as much as possible.
2. The connecting pipeline (including the oil tank) must be completely cleaned and well sealed before processing.
3. When operating the oil filter, it must be operated strictly by the operating instructions.
4. The oil filter may contain some mechanical impurities and free water in the equipment that has been used repeatedly. When it is used again, the bottom water and impurities must be removed in advance before filtering to extend the service life of the oil filter.
5. During operation, the working conditions of the oil filter should be strictly monitored, such as vacuum, flow, temperature, etc., and the quality of the oil before and after treatment should be regularly tested. To monitor the purification effect of the oil filter.
1. When used in winter, the pipelines, vacuum tanks and other components should be insulated. When filtering oil in the substation, the relevant provisions of the electrical safety work regulations issued by the power industry must also be observed.
2. When the oil filter is working, the oil to be filtered is sucked into the strong magnetic filter under the action of the outside atmosphere and vacuum suction, and large particles of impurities are filtered out. The oil is heated by the heater and enters the multi-stage coalescence water filter. Because the water filter adopts the enhanced oleophilic and hydrophobic technology, the interaction force between the oil and water phases is improved, so that the fine water droplets in the oil are accelerated, and the large water droplets are separated from the oil and precipitated in the pure water storage tank.
3. The oil with impurities removed enters the three-dimensional vacuum flash tower. After the spray device, the oil is on the flash ball ring to produce a larger aeration area and a longer retention time for the oil, and a sufficient oil and gas separation process is carried out to remove the residual trace water and gas in the oil.