Working principle of regeneration oil filter

The main principles of the regeneration oil filter include mechanical filtration and chemical treatment. Mechanical filtration uses a filter to filter the grease to remove solid impurities and particulate matter. Chemical treatment improves the quality and performance of the grease by adding specific chemicals, such as antioxidants, rust inhibitors, etc.

Specifically, the working process of the regeneration oil filter can be divided into the following steps:

Pre-filtration: Add the grease to be filtered into the oil tank of the oil filter. After starting the machine, the grease is first filtered through a coarse filter to remove larger impurities and particulate matter.

Fine filtration: The grease that has been initially filtered then enters the fine filter for more detailed filtration to remove smaller impurities and particulate matter.

Chemical treatment: During the fine filtration process, the quality and performance of the grease are improved by adding chemicals, such as antioxidants, rust inhibitors, etc.

Dehydration: The finely filtered grease may contain a certain amount of water, and the water needs to be removed through a dehydration device.

Recirculation filtration: The grease after the above treatment may not necessarily meet the use requirements, so the grease needs to be circulated and filtered again to ensure that the quality and performance of the grease meet the requirements.

How to use

The following steps need to be followed when using the oil filter:

Preparation: Pour the grease to be filtered into the oil tank and prepare chemicals such as antioxidants, rust inhibitors, etc. At the same time, it is necessary to check whether the filter and dehydration device are normal.

Start the machine: Pour the grease in the oil tank into the machine, press the start button, and start filtering and regeneration.

Observe the operation: During the operation of the machine, it is necessary to observe the operation to ensure that the filter and dehydration device are working properly. If the oil level is too low, the machine needs to be stopped in time and grease needs to be added.

Take out the filtered grease: After filtering and regeneration are completed, take out the filtered grease.

In short, the regeneration oil filter is a very practical equipment that can effectively improve the quality and life of the grease. When using the oil filter, it is necessary to pay attention to correct use and maintenance to ensure the normal operation and effect of the machine.