E-mail sinonshseo@gmail.com
Time:2025-03-18 13:55:30 Reading volume:
Preparations before installation and commissioning of vacuum oil filter
All parts of the oil filter produced by the regular oil filter factory have been adjusted and tested before leaving the factory. When transported to the site of use, it is necessary to check whether all parts (electrical appliances, instruments, etc.) are intact and whether the fasteners are loose (mainly considering whether there are signs of looseness during transportation).
(1) The machine should be placed on level ground, with the oil inlet connected to the oil drain at the bottom of the oil tank and the oil outlet connected to the top of the oil tank.
(2) Since the machine is mobile, the user does not need to design an installation foundation separately, just move the machine to a flat ground near the oil to be processed.
(3) The selection of the power supply line must be based on the total power of the vacuum oil filter and the maximum current that can be supported by the machine.
(1) Connect the inlet and outlet pipes of the vacuum oil filter equipment (the hose and the metal pipe should be tightened with a clamp) to ensure that the oil path from the oil tank to the machine is unobstructed.
(2) Connect the power cord correctly, confirm that the inlet and outlet oil pipes are firmly connected, the phase sequence of the power supply line is correct, the power supply voltage matches the equipment, and the electronic control system is in standby mode.
(3) Check whether there are any factors that affect the operation of the equipment around, and start the machine only after confirming that everything is normal.
(4) Equipment trial run: Close the drain valves, sampling valves and air seepage valves connected to the outside world, start the vacuum pump and observe the display of the vacuum meter - the vacuum degree will rise slowly, otherwise the power supply line phase should be changed. During the trial run inspection, the equipment should not swing or vibrate.
Note:
Generally, all parameters of the vacuum oil filter are set internally when the machine is tested before leaving the factory. Users can make corresponding changes during debugging according to special needs.