Cleaning and maintenance of vacuum oil filter element

The vacuum oil filter is a family of oil filters and a common oil filter variety. But the price of vacuum oil filters ranges from 20,000 to 200,000, from 100,000 to 200,000, or even higher. For many companies, this is an asset investment, so they all expect a long service life, so it is naturally indispensable and needs cleaning and maintenance. Let's learn about it today.

There is no doubt that the normal cleaning and maintenance of the main oil filter will definitely increase the service life, so we should correctly choose the filter element of the vacuum oil filter, because the type of filter element and equipment is matched. If the selection is improper, it will affect the filtering effect.

Precautions for cleaning the vacuum oil filter:

First, the filter element of the vacuum oil filter needs to be cleaned and replaced in time, because when it purifies the oil, the impurities next to the oil are concentrated on the filter element. If it is not clear for a long time, it will cause the oil filtration speed to slow down and the oil quality is not clean enough.

Second, the shaft pressure cannot be increased during use. Assuming that the oil can pass through the filter quickly in this case, the filter element is often crushed, affecting the cleanliness of the hydraulic oil.

To ensure the cleaning of the vacuum oil filter element, we need to clean the vacuum oil filter element in time. The method is introduced as follows:

1. Before cleaning the vacuum oil filter, it is necessary to intermittently work the oil filter, close the inlet and outlet oil pipes, and turn off the power switch.

2. Open the oil drain valve to drain all the oil in the filter until the oil flow is completed (the oil drain valve can be opened when draining the oil to speed up the draining speed).

3. After placing, open the filter cover and take out the filter element.

4. Vacuum oil filter element, take out the filter element, put it in the oil pan filled with kerosene, soak it for 30 minutes, clean it, and blow it dry with air.

5. Use a brush to remove the sediment on the surface of the vacuum oil filter, and then clean the filter with a rag.

6. Then install the filter element and lock the filter element bolts. It can only be put into use after cleaning.

It should be reminded that the frequency of use of vacuum oil filters is generally not very high. Enterprises generally collect oil products that have been filtered for half a year or a year, and some may be directly connected to the equipment for filtering. No matter which method is used, after using the vacuum oil filter, the inside of the machine must be cleaned once with the filtered oil of the same type, and then the cleaned oil must be cleaned. Companies with fans can use fans to blow dry the inside, because some manufacturers' vacuum oil filters are not well handled, and they will rust if not blown dry.

In a word, the vacuum oil filter also needs to be carefully maintained. No matter what the manufacturer of the oil filter is, if you don't learn to clean and maintain it well, I think we can imagine what the result will be, so it is very important to do a good job of cleaning and maintenance.